山東山汽工程機械(集團)有限公司
熱線電話:400-879-1999 山汽官方微信
鄭重聲明 購機 售后
在線詢價
熱線電話:400-879-1999
您現在所在的位置: 首頁> 常見問題 >

混凝土攪拌機出現抱軸的原因是什么?

所屬分類:常見問題 發布時間:2022-04-09 來源:http://www.corajawali.com 瀏覽量:18

混凝土攪拌機是生產混凝土的主要設備,混凝土攪拌機是把水泥、砂石骨料和水混合并拌制成混凝土混合料的機械。在使用過程中要注意日常保養,如果不注意保養,可能會出現抱軸的情況,混凝土攪拌機出現抱軸的原因也是有多種的。
Concrete mixer is the main equipment for producing concrete. Concrete mixer is a machine that mixes cement, gravel aggregate and water into concrete mixture. Pay attention to daily maintenance during use. If you don't pay attention to maintenance, axle holding may occur. There are many reasons for axle holding of concrete mixer.
1、混凝土攪拌機,可能是原料投料位置問題。攪拌混凝土所用的物料主要是砂石骨料、水泥、粉煤灰、水喝外加劑等。原料水泥若包裹砂石遇水結塊,如果攪拌不充分就容易粘在攪拌軸上,若水泥進料口位置方向不合理,使攪拌軸不能快速充分攪拌,就容易形成抱軸現象。
1. The concrete mixer may be due to the feeding position of raw materials. The materials used for mixing concrete are mainly sand and gravel aggregate, cement, fly ash, water and drinking admixture, etc. If the raw cement is wrapped with sand and stone and agglomerates with water, it is easy to stick to the mixing shaft if it is not fully stirred. If the position and direction of the cement feed inlet is unreasonable, the mixing shaft cannot be quickly and fully stirred, and it is easy to form the phenomenon of shaft holding.
2、混凝土攪拌機進水管與沖水位置原因。沖水點位置和沖洗方向不正確的話,又或者是沖水壓力過低,導致水在進入主機內部后,不能將暫時粘結在軸上的混凝土沖洗掉,則時間久了就容易形成抱軸。
2. Reasons for water inlet pipe and flushing position of concrete mixer. If the position and direction of the flushing point are incorrect, or the flushing pressure is too low, so that the water cannot flush the concrete temporarily bonded to the shaft after entering the main engine, it is easy to form the shaft holding after a long time.
3、混凝土攪拌機,在結構生產之后沒有及時對混凝土攪拌機內部進行清洗,或清洗的不干凈,導致攪拌軸表面仍有殘留的混凝土,干燥后凝固在攪拌軸上,如果長期如此則非常容易產生抱軸現象。
3. For the concrete mixer, the interior of the concrete mixer is not cleaned in time after the structural production, or the cleaning is not clean, resulting in the residual concrete on the surface of the mixing shaft, which is solidified on the mixing shaft after drying. If this is the case for a long time, it is very easy to produce the phenomenon of shaft holding.
以上就是為大家介紹的有自動攪拌一體機的詳細介紹,希望對您有所幫助.如果您有什么疑問的話,歡迎聯系我們.我們將以的態度,為您提供服務http://www.shanqijituan.cn/
The above is a detailed introduction of the automatic mixing machine. I hope it will be helpful to you If you have any questions, please contact us We will provide you with professional service http://www.shanqijituan.cn/
熱門產品 / HOT PRODUCT

 

首頁 產品 電話 置頂
青青青免费手机版视频在线观看